Products

Products
1964 - 1970 Ford Mustang Door Latch Screws.
Correct screws with special star washers. Set of six
$10.00
1964 - 1970 FORD MUSTANG EQUALIZER BAR REPAIR KIT...
A must for all manual transmissions. Includes felt washers, nylon ball bushings, washer and clevis clips. Improves clutch operation. Fits...
$35.00
1964 - 1970 Ford Mustang Export brace black
Concours reproduction manufactured from original Ford prints for a precise, factory-style fit. Heavy gauge steel construction provides long-lasting durability. A...
$95.00
1964 - 1970 Ford Mustang Export Brace Chrome.
Concours reproduction manufactured from original Ford prints for a precise, factory-style fit. Heavy gauge steel construction provides long-lasting durability. A...
$165.00
1964 - 1970 FORD MUSTANG EXPORT BRACE MOUNTING PLATE
Reinforcement plate that mounts on cowl.
$82.00
1964 - 1970 Ford Mustang Fender To Cowl Nut...
Pair of captive nuts on stamped steel winged plates. Snaps into rocker. Very special nut hard to find.
$13.00
1964 - 1970 FORD MUSTANG FRONT FRAME RAIL (1...
This original style, 1 piece front frame rail is the best replacement available. Provides original appearance and strength when installed.
$400.00
1964 - 1970 FORD MUSTANG FRONT FRAME RAIL (1...
This original style, 1 piece front frame rail is the best replacement available. Provides original appearance and strength when installed.
$400.00
1964 - 1970 Ford Mustang Full Floor Pan Coupe...
Replace the whole side at once and save time.
$200.00
1964 - 1970 FORD MUSTANG HEATER DEFROSTER DUCT CLIP...
These clips hold the defroster outlet nozzles to the dashboard. Four (one set) are required for a complete installation.
$7.00
1964 - 1970 Ford Mustang Heater Inlet Gasket
This gasket seals the fresh air tube in the cowl to the heater box inlet on 1964 through 1970 Mustangs.
$11.00
1964 - 1970 Ford Mustang Heater To Firewall Seal
This foam rubber seal fits between the inner firewall and the heater box intake to seal out water and debris....
$6.00
1964 - 1970 FORD MUSTANG IMPROVED TRI-Y POWER STEERING...
Newly improved Tri-Y Power Steering Drop Bracket are now available from Scott Drake. This bracket is a must for the...
$57.00
1964 - 1970 Ford Mustang License Plate Bumpers, Pair
These little bumpers remove big rattles. Fits front or rear valances. 1964-68 front and 1964-70 rear. Sold as a pair.
$6.00
1964 - 1970 Ford Mustang License Plate Bumpers.
These little bumpers remove big rattles. Fits front or rear valances. 1964-68 front and 1964-70 rear. Sold as a pair.
$4.00
1964 - 1970 Ford Mustang Outer Rear Axle Bumper.
Injected molded rubber. Protects floor, and stops 3rd member from contacting floor.
$17.00
1964 - 1970 Ford Mustang Power Steering Ball &...
Includes ball and stud kit and all seals necessary to stop leaks and reduce excess play in steering wheel.
$105.00
1964 - 1970 FORD MUSTANG POWER STEERING CONTROL VALVE...
Includes all seals, gaskets and “O” rings needed to stop leaks. Makes your control valve perform properly.
$52.00
1964 - 1970 FORD MUSTANG POWER STEERING CONTROL VALVE...
Direct-fit replacement installs inside the power steering control valve Regulates volume of fluid in relation to engine & power steering...
$103.00
1964 - 1970 FORD MUSTANG POWER STEERING CYLINDER BOOT...
This power steering cylinder boot kit is designed to protect your steering cylinder from any dirt or dust entering your...
$37.00
1964 - 1970 FORD MUSTANG POWER STEERING VALVE SOCKET...
This bronze/steel sleeve should be replaced to do a proper rebuild on your control valve.
$62.00
1964 - 1970 Ford Mustang Rear Brake Spring 9”...
These kits contain all the replacement springs and hold downs required to do a professional job on drum brakes. Kit...
$29.00
1964 - 1970 FORD MUSTANG REAR END VENT HOSE...
New by Scott Drake, this Rear End Vent Hose Kit allows the rear end to breath. It runs from the...
$27.00
1964 - 1970 FORD MUSTANG REAR FRAME RAIL RH
The best frame rail available. Gives the original appearance and strength when installed. Original style.
$142.00
1964 - 1970 FORD MUSTANG REPRODUCTION FRAME RAIL LH
The best frame rail available. Gives the original appearance and strength when installed. Original style.
$142.00
1964 - 1970 FORD MUSTANG SB EQUALIZER PIVOT BRACKET
Made by Scott Drake, this Equalizer Pivot Mount for 1964-70 Mustangs is stamped from heavy gauge steel and finished with...
$46.00
1964 - 1970 FORD MUSTANG SEAT ACCESS HOLE PLUG
Molded rubber. Ours feature the right details including stamped engineering numbers on top.
$3.00
1964 - 1970 FORD MUSTANG SEAT HINGE SHAFT RETAINER...
Special clip used to secure front seat back to seat bottom. Two required per seat.
$8.00
1964 - 1970 Ford Mustang Seat Retaining Nuts
Another exact reproduction by Scott Drake. Painted to prevent rust. Color is dark red. Sold in sets of 4.
$16.00
1964 - 1970 FORD MUSTANG SEAT TRACK BOLTS (SET...
Made by Scott Drake with exact detail. Not just a generic replacement bolt. A commonly rusted or missing part now...
$15.00
1964 - 1970 Ford Mustang Shock Absorber Kit Front...
Complete set font and rear FCS shock absorber kit
$275.00
1964 - 1970 Ford Mustang Shock Absorber Kit Front...
Complete set font and rear KYB shock absorber kit
$290.00
1964 - 1970 FORD MUSTANG STEERING BOX COVER GASKET
A leak coming from the steering box can sometimes be traced to the gasket at the steering box cover on...
$9.00
1964 - 1970 FORD MUSTANG STRIKER PLATE SCREWS
Four gold cadium plated screws to attach door strikers to 1964 through 1970 Mustangs.
$11.00
1964 - 1970 Ford Mustang Trunk Floor LH.
Drivers side trunk floor, made as original.
$100.00
1964 - 1970 Ford Mustang Trunk Floor RH.
Passenger side trunk floor sheet metal made as original.
$100.00
1964 - 1970 MUSTANG BUCKET SEAT TRACK ADJUSTER
New from Scott Drake is the 1964-70 Mustang Bucket Seat Track Adjuster. This commonly missing part is a must to...
$19.00
1964 - 1970 MUSTANG CONVERTIBLE CENTER INNER TRUNK BRACE
To rebuild or replace the brace for the trunk floor.
$121.00
params.svg
Panel Tool
Float header
Float topbar
Default Boxed Large Boxed Medium